China Home Elevator Manufacturers Introduces The Installation Details Of The Micro Elevator
China Home Elevator Manufacturers introduces the installation process of micro elevators: 1. Vertically penetrating hoistway space. According to the installation position, the elevator can be installed in the middle of the stairs, civil construction hoistway, against the wall, etc., no matter where it is installed, there needs to be a vertically penetrating space. This is especially important when cutting floor slabs to install household miniature elevators. In many cases, the communication between the owner and the construction team is not good, and it is easy to happen: the holes cut on each floor have the same size, but they are not connected in the vertical space. The elevator cannot be installed, and a second construction is required, which is a waste of time and manpower. 2. Reserve enough top height. For safety reasons or due to the structure of the elevator itself, sufficient top height space should be reserved for elevator installation. 3. Determine the location of the power supply and wiring. Because each home has different owner needs, the base station is different, the structure is different, and the power supply location is also different. 4. The hard installation work at home is completed. As a precision large household appliance, the elevator needs special attention to prevent dust pollution during installation and daily maintenance. If the elevator has been installed before the house decoration, a large amount of dust generated during the decoration process will enter the elevator. On the one hand, it is difficult to clean up. More importantly, the fine dust enters the elevator structure, which will affect the normal operation of the elevator and greatly shorten the elevator’s operation. Service life.
Through the above introduction,China Home Elevator Factory hopes that you can simply refer to the content of this article in future use.
