China Industrial Sprocket Company Introduces The Strategy For The Treatment Of Chain Carbon Deposits

When stainless steel chains are used in mechanical equipment, some dirt will inevitably be attached, most of which are carbon deposits and oil stains. However, there are many dead spots on the stainless steel chain. These carbon deposits and oil stains will be very difficult to remove. Below, China Industrial Sprocket Company will introduce how to make it easier?

If you find carbon deposits on the stainless steel chain, you must ensure that it is removed without damaging the chain. In this way, it seems that only chemical and mechanical methods can be used. The so-called chemical method is to directly immerse the stainless steel chain in a prepared chemical solution, wait until the carbon deposits are softened and loosen, then take out the parts, wipe them with a brush or cotton thread, and then wash them with hot water.

The mechanical method to remove the stainless steel chain is to use metal brushes, shovels, and other tools to remove the carbon deposits. In contrast, although the mechanical method is simple, it is difficult to completely remove the carbon deposits, and the oil may make the stainless steel chain in the cleaning process Damaged.

If the stainless steel chain is stained with oil instead of carbon deposits, the cleaning method must be changed. For example, organic solvents and alkaline solutions can remove it, so that the stainless steel chain can restore its new surface and good performance. So as to ensure better use effect.

When using a stainless steel chain, in addition to keeping it clean, you must also pay attention to the strength of the joint. If the strength is not up to the requirement, try not to use it, so as not to affect the future use of the stainless steel chain.

Through the above introduction, China Conveyor Chains Company hopes that you can simply refer to the content of this article in future use.