China Rubber Rings Factory Introduces The Burr Treatment Process Of Rubber Seals

When rubber seals are produced, it is inevitable that there will be burrs. Therefore, it is important to treat the burrs in time when they encounter burrs. However, many people do not know how to treat the burrs to achieve a non-destructive effect. So, below, China Rubber Rings Factory will take a look at its common processing methods.

1. Manual processing. When the burrs of the rubber seals are processed, you can choose manual trimming treatment. This method is very labor-intensive, and the efficiency is relatively low. When trimming the burrs, it is easy to cause damage to the rubber seals. It is a method with a relatively low pass rate.

2. Mechanical trimming. Its trimming method is mainly corrected by punching, round knife trimming and grinding wheel edging, etc. It is more suitable for rubber seals that do not require high accuracy. However, if the accuracy requirements are relatively high, then use Mechanical trimming may induce abnormalities.

3. Frozen trimming. This is a method of trimming using a special refrigeration equipment machine. It uses liquid nitrogen to process the burrs of the finished product. These burrs will become more brittle in the low temperature state, and then use the relevant The frozen ions are used to strike the burrs, so that the burrs can be quickly processed. This trimming method is more efficient and low in cost. It is currently the mainstream method for repairing the burrs of rubber seals.

Through the above introduction, China Pe Tubes Company hopes that you can simply refer to the content of this article in future use.