Plastic Balls Manufacturer Introduces The Characteristics Of Silicone

Plastic Balls Manufacturer introduces the main materials of O-rings:

1. Nitrile rubber (NBR): This material has a maximum temperature of 130 degrees, a hardness of 50-90 degrees, and a complete range of specifications. It has good mechanical properties and is resistant to mineral-based lubricating oil and grease.

2. Fluorine rubber (FPM): The temperature of this material can reach a high temperature of 240 degrees. It has a complete range of specifications. It is known for its high temperature resistance and chemical resistance. In addition, it also has good anti-aging and anti-oxidation, very low gas permeability (especially suitable for true high-altitude installations).

3. EPDM: The temperature range is -50 degrees to 150 degrees, and it has the characteristics of heat resistance, steam resistance, aging resistance and chemical resistance. It is suitable for hot water, steam, detergent, potassium hydroxide solution, silicone oil and grease, a variety of dilute acids and chemical (medicine) products. It is especially recommended for its resistance to glycol brake fluid, but it is not compatible with all mineral oil products (lubricating oil, fuel).

4. Silicone (SI): Silicone rubber has the widest operating temperature range (-60-180°C), is harmless, non-toxic and tasteless, has excellent resistance to ozone aging, oxygen aging, light aging and weathering resistance, and excellent Electrical insulation properties, special surface properties and physiological inertia, high air permeability

5. There are many kinds of materials such as: polyurethane rubber (PU) natural rubber (NR) butyl rubber (BU) sulfonated vulcanized polyethylene (CSM) polytetrafluoroethylene (PTFE) neoprene (CR) acrylate Various materials such as rubber (ACM).

Through the above introduction, Steel Balls Wholesaler hopes that you can simply refer to the content of this article in future use.