Plastic Balls Manufacturer Introduces The Cleaning Features Of Pe Pipes

During the long-term storage and flow of PE pipes, a lot of dust, debris and other debris will accumulate in the PE pipes. Plastic Balls Manufacturer  introduced that for these dust and debris, the usual cleaning method is blowing and cleaning. The following is the specific operation process:

  1. The medium of the purge experiment should be compressed air, and its temperature should not exceed 40 degrees Celsius.

  2. When purging, the PE pipe should be isolated from irrelevant systems and systems in operation, and should be marked with obvious signs, and valves should not be used for isolation.

  3. Pressure regulators, condensate tanks, valves and other equipment are not involved in purging and can be installed after purging is qualified.

  4. The purge outlet should be located in an open area, and reinforcement measures should be taken; the exhaust outlet should be grounded. Set up a safe area when purging, and it is strictly forbidden to stand at the purge outlet.

  5. The purge gas pressure should not be greater than 0.3MPa. The flow rate of the purge gas should not be less than 20m/s and should not be greater than 40m/s.

  6. The length of the PE pipe should be determined according to the purging medium, pressure and air volume, and should not exceed 500m.

  7. If there is no smoke and dust in the exhaust, a white cloth or a wooden target plate coated with white paint should be installed in the exhaust port for inspection. There is no dust on the target within 5 minutes, plastic debris and other debris are qualified.

Through the above introduction, Steel Balls Wholesaler hopes that you can simply refer to the content of this article in future use.