Plastic Balls Manufacturer Introduces The Cleaning Requirements Of O-Shaped Rubber Seals

O-type rubber seals are affected by various external environmental factors, such as deformation, oxygen, ozone, light, heat source, humidity, oil or chemical solvents, etc. Next, Plastic Balls Manufacturer  will introduce the storage method of O-shaped rubber seals:

1. Temperature: 5-25℃ is the ideal storage temperature. Avoid contact with heat sources and sunlight. Seals removed from low-temperature storage should be placed in an environment of 20°C before use.

2. Humidity: The relative humidity of the warehouse should be less than 70% to avoid excessive humidity or excessive dryness and condensation.

3. Lighting: Avoid sunlight and strong artificial light sources containing ultraviolet rays. Anti-ultraviolet packaging bags provide better protection. It is recommended that the windows of the warehouse be painted with red or orange paint or film.

4. Radiation: Avoid damage to seals caused by ionizing radiation.

5. Oxygen and ozone: rubber materials should be avoided from being exposed to circulating air. This can be achieved by packaging, winding, storage in airtight containers or other suitable methods. Ozone is harmful to most elastomers. The following equipment should be avoided in the warehouse: mercury vapor lamps, high-voltage electrical equipment, motors and other equipment.

6. Deformation: Rubber parts should be placed as freely as possible to avoid stretching, compression or other deformation.

7. Contact with liquid or semi-solid materials: no solvent, oil, grease or other semi-solid materials.

8. It is not allowed to touch metal or non-metal materials: magnetic materials, cast iron, copper and its alloys or materials that may damage rubber. Polyvinyl chloride materials cannot be used for packaging seals. Seals of different materials must not be mixed.

9. Cleaning: As needed, soap and water can be used to clean the seals. However, water is not allowed to contact fiber-reinforced seals, rubber-metal bonded seals, and gold seals. Do not use disinfectants, organic solvents and sharp tools. The cleaned seal should be dry at room temperature and not close to the heat source.

Through the above introduction, Steel Balls Wholesaler hopes that you can simply refer to the content of this article in future use.