Stainless Steel Bathroom Faucet Manufacturers Share Hot And Cold Faucets Are Common Faucets
The hot and cold water tap is a type of faucet that is currently used at home. It can flow out cold water that is not heated normally, or it can flow out of warm water. So, do you know the working principle of the hot and cold water tap and its installation method? Today, the manufacturer of Stainless Steel Bathroom Faucet will give you a brief introduction.
The main hot and cold water faucet consists of a handle, a valve core, a water inlet braided tube and mounting gadgets. The working principle of the ceramic valve core: In general, the bottom of the ceramic valve core consists of three holes, one of which is used for entering and leaving cold water, the other is for entering and leaving hot water, and the other one is used for water supply inside the spool. The faucet valve core has cold and hot two holes with sealing ring to ensure that it is sealed with the main inclined street. After connecting the main body of the cold and hot water pipe, ensure that the hot water pipe and the cold water pipe are in one-to-one correspondence with the two holes of the valve core. The spool mainly controls the opening and closing of the two holes and relies on the movement of the two ceramic sheets to work.
The handle switch drives the valve stem to move, so that the ceramic piece moves, and the left and right holes are sealed, and the valve core is not watered at this time. The step seal of the spool allows the water flow to pass through the spool to enter the main body outlet passage so that no water enters the spool and no water flows out of the conduit. This is the closed state of the water pipe, the structure of the faucet and the working principle.
1, kitchen hot and cold water faucet installationIn the kitchen, only the sink and the sink need to be equipped with hot and cold water faucets. This faucet is relatively simple to install. Generally, there are two hoses, copper buckles, rubber pads, faucets, etc., and the copper buckles and rubber pads are placed in the soft. tube. Then connect the hose to the hole in the sink, then transfer the rubber pad to the hose, transfer the copper wire into the hose, and then place the faucet on the copper wire tube. At the same time, the copper wire should also be fixed firmly. Finally, put it into the hole interface of the sink, then tighten it, then talk about the same hose to access the water outlet. It is best to mark the cold water pipe, otherwise it will be wrong to use.
2, bathroom hot and cold water faucet installationWhen installing the bathroom hot and cold water faucet, you need to express the hot and cold water pipes separately. Generally, the red color on the left side is connected to the hot water, and the blue color on the right side is connected to the cold water. At the interface, it is necessary to use a waterproof tape to wrap a few turns to prevent water leakage, then connect the faucet to the interface and tighten with a wrench. Then open the faucet and test it according to the cold and hot, there is no running water. The hooks of the bathroom showers are generally installed and adjusted according to the height of the user. Hand-held vertical hand showers are a common type of shower. The installation height is generally 2050mm-2200mm, and the height of the ceiling shower is generally 2100mm-2300mm. It is necessary to consider the height of the user when installing.
information about Stainless Steel Bathroom Faucet : https://www.afastainlesskb.com/product/stainless-steel-faucet/bathroom-faucet/
