Stainless Steel Faucet Supplier Introduces The Rules Of Cabinet Installation
Stainless Steel Faucet Supplier introduces the points to note when installing stainless steel cabinets:
1. Overall situation: The layout of U stainless steel cabinets can make the washing area, cooking area, and storage area of the kitchen clearly divided, and the space utilization rate is high, and people’s activity and operation space will not be too narrow.
2. Detailed explanation of the cabinet design drawing: There are many plates and various hardware used in the installation of stainless steel cabinets, which are easy to confuse. Because the installation is not in place or there is damage during the installation process and the expected effect cannot be achieved, so in the installation of indoor cabinets, the guidance of cabinet design drawings is required. The cabinet design drawings indicate in detail the size of each component and the board assembly of each cabinet. In addition, there are reminders about the kitchen piping and the location where nails cannot be nailed.
3. Wall cabinet measurement: The cabinet wall cabinet can be a wall or a mezzanine, so as to ensure effective use of space without deformation, but it must be horizontal at the top and bottom and vertical on both sides. If there is an error, it is required The height difference between the left and right sides of the opening is less than 5mm, and the bottom wheel of the cabinet door can make up for the error through the debugging system.
4. Track reserved size: when making the cabinet, it is necessary to reserve the size for the track. The reserved size for the upper and lower tracks is 200px for folding doors and 250px for sliding doors.
5. Cabinet door installation: first fix the top rail of the stainless steel cabinet door in Chengdu, the front surface of the rail and the cabinet surface are on the same plane, and the upper and lower rails are placed flat in the reserved position. Then put the two doors into the rails, measure the verticality of the door with a level or ruler, adjust the position of the upper and lower rails and fix them. Check again whether the door is parallel to both sides. You can adjust the door by adjusting the bottom wheel to reach the level of the frame and both sides. Finally, fix the anti-jumping device and display the quality protection certificate. Home cabinets generally have drawer designs. In order not to affect the design position of the drawers, you should pay attention: when making three sliding doors, avoid two intersecting places, and making two sliding doors should be placed on one side of the door. When the folding door is manufactured, the side walls of the drawer should have a gap of 425px.
Through the above introduction, Stainless Steel Faucets Manufacturers hopes that you can simply refer to the content of this article in future use.
