Stainless Steel Sink Manufacturers Explain How To Solve Water Leakage At The Edge Of The Sink

When the decoration is done, the master who installed the cabinet is usually responsible for installing the sink. Some of them are the stone masters who install the sink. Maybe after they have finished installing it, they have tested it and there is no water leakage. But after the house has been cool for several months, it has been found. The edge of the sink leaks. So today, Afa Stainless Steel Sink Manufacturers will introduce the leaking water at the edge of the sink.

Water leaking from the sink is easy to wet the cabinet. Most of the cabinets are made of custom particleboard. If the sealing performance of the particle board is not good, it will enter the particleboard to cause expansion and become moldy and decaying. Therefore, it must be taken seriously.

1. If the faucet leaks, it is generally leaking along the junction of the faucet and the sink. Then it is definitely a problem with the seal. Fix the large nut off the bottom fixed faucet. If it is still not working, it may be the rubber pad. Loosen the large nut and then put it on the rubber pad, which can usually be solved.

2. If there is water leakage in the hot and cold water pipes of the faucet, the hot and cold water pipes of the faucet are screwed to the bottom of the faucet. Similarly, the screw can be tightened, which can generally be solved. If it still doesn’t work, it is very likely that the rubber mat is out of order. Unscrew the hot and cold water pipes and see what happens to the rubber mat. After repairing, tighten it.

3. There is a gap between the sink and the countertop. It can be solved with glass glue. Buy the glass glue, then apply it to the gap. Wait for about 24 hours. Do not use or tamper with the water tank. After the glass glue is solidified. , you can use it. It is important to note that the surrounding moisture must be dried before application.

4. the water pipe leakage is more common. If the water is leaking in the place where the water pipe is turned, the place where the water pipe is turned is not easy to remove. Even if it is removed, it is difficult to install it. Therefore, I suggest that you use a glass glue or a hot melt glue gun to apply it for a week in this rotating place. After drying, I believe it can be solved. If the water is leaking in the place where the water pipe nut is screwed, if the nut is tightened and the rubber pad cannot be solved, it can be wrapped around the raw material tape and then tightened. Generally, it can be solved.

5. the wall of the sink has a gap, this is more troublesome, generally I suggest that you still replace some, welding, you have to find a professional stainless steel welding place, you need to disassemble, and the welding will leave a very ugly weld mark.

information about Stainless Steel Sink Manufacturers : https://www.afastainlesskb.com/product/stainless-steel-sink/