• $200000

China Stainless Steel Sink Correct Installation Procedure

I don’t know if you have encountered such a situation after renovation. The kitchen sink has not been used too much. There are also a series of problems, such as rust, mildew, dark spots, water leaks, etc., so that you don’t even cook. mood. In fact, these problems are caused by neglecting the details when installing the sink. What is the correct procedure for installing a China Stainless Steel Sink ?

Usually, the steps to install a Chinese stainless steel sink are as follows:Fixed position – Installation of faucets and inlet pipes – Sinks placed on work surfaces – Overflow holes, filter seals – Installation of pendants – Drainage test – Edge seals – Cleaning.

1, fixed positionBefore installing the receiver, you must first determine the location and size of the installation. This makes it easy for us to order according to size. It is best to have a receiver plan to avoid inaccurate data and lead to rework. In addition, after the sink is installed firmly, do not shake it from side to side, and it is easy to leave a gap and cause looseness. In addition, the most important thing is to pay attention to the tightness of the joint space.

2. Install the faucet and inlet pipeBefore installing the sink, the faucet and inlet pipe should be fixed first, and the inlet pipe at the other end should be connected to the water inlet switch.

3. After placing the sink on the work surface, a matching pendant is required between the wall and the work surface. However, pay attention to the sealing effect of the sink as much as possible during the installation process.

4. Overflow hole, filterThe degree of sealing of the overflow and the filter determines the effect of using the sink in the future. The higher the degree of sealing of the overflow hole and the filter, the less likely it is that problems will occur at a later stage.

5. Install the support pendantThe installation of the support pendant is generally considered to be the last step in the installation of the sink. Usually, only when buying a sink, the worker cuts the countertops according to the size of the sink and places them on the countertop. When installing, each gap should be filled to avoid water leakage problems in the future.

6. Drainage acceptanceAfter the entire installation of the water tank is completed, the water tank needs to be filled with water to carry out a drainage test. If there is a leak, you should immediately find the problem.

7. Edge bandingThe drain test ensures that the sink can be the edge after no problem. When sealing with silicone, make sure that the gap between the sink and the table is even and that there is no water seepage.

8. Clean upAfter installation, the sink must be cleaned to remove debris from the installation process. Do not flush directly into the water with water, it is easy to cause a blockage.

Tip: Finally, add some notes to the sink decoration.a. Sink installation should be left at the end to avoid damage during refurbishment. When installing the water tank, remember the water in the drain pipe, otherwise, it will cause problems such as water leakage and rust.

C. The faucet must be installed firmly at the junction of the pillows. If there is a gap, it will cause water leakage.

d. Rusting in the sink. It can be wiped with toothpaste. It will disappear naturally after normal use. That is, it is preferable to apply glass glue to the joint between the water tank and the drain pipe.

 

information about China Stainless Steel Sink : https://www.afastainlesskb.com/product/stainless-steel-sink/