Stainless Steel Handle Made Sink Manufacturers Share The Processing Of Opening At The Sink
When installing stainless steel sinks, the problem of opening the stainless steel sink is very important. Stainless Steel Handmade Sink Manufacturers In order to avoid the troubles of future users, here is a brief introduction to what should be paid attention to in the stainless steel sink. I hope to help you:1. Confirm the size of the sink and its hole (the arc of the four corners of the water hole).2. According to the drawing, determine the center position of the sink, use the template to position or draw the opening line according to the hole size.3. First open the hole with the hole opener at the four corners of the hole, and then use the machine to open the hole along the hole.4. Mill the edge of the hole to the corresponding edge according to the drawing.5. Evenly apply the glass glue to the bottom edge of the sink hole, place the water tank on the hole of the opened sink, stick the reinforcement block, and strengthen it with strong AB glue. After the glue is solidified, seal the glue.6. When milling the hole shape of the sink and installing the sink, it is necessary to distinguish the front and back of the table.7. If the sink is used as a countertop, the countertop does not need to be disposed of during factory processing.8. If the above-ground basin is installed on site, draw the opening line according to the opening template of the water tank. Firstly, open the round hole with the hole opener at the four corners of the hole position, and then use the machine to open the hole along the opening line.9. Evenly apply glass glue on the edge of the sink, install it in the hole of the finished sink, clean the excess glass glue, and wait for the glue to solidify.
information about Stainless Steel Handmade Sink Manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/
